Generally, plumbing issues are handled in the wrong way leading to further worsening of the issue. Most homeowners try to do the plumbing repairs themselves from installing and repairing sinks to clearing of the clogged drains. But this can be hard on their sanity and lead to a big dent in their finances and also end up in big mechanical damage.
Identifying the Issue
Plumbing issues can be diagnosed easily by the noise factor. Determining the source of the noise will help you find the right solution. For instance, noises on the inlet part of the plumbing system can occur due to:
• High water pressure
• Damaged or worn faucet and valves
• Pumps not connected properly
• Improperly fixed pipe fasteners and wrong plumbing runs
A noise on the drain side is mostly due to poor location and tight bends in the layout.
The Solution
Hissing noise due to high pressure of water can be solved by installing a valve that reduces the pressure of the water. Thudding noise or water hammer caused due to reverberating water pressure waves can be cured by using air chambers or shock absorbers in the problematic area.
Tapping, squeaking, snapping, creaking, and scratching sounds are due to contracted or expanded pipes and these occur with copper pipes mostly. Foam pipe insulation done around the pipes at the point of contact will remedy the issue.
Avoiding Plumbing Issues
• If you have galvanized steel and copper plumbing together in your plumbing system, it can corrode easily. Dielectric union fitting should be used as connector for the two different types to prevent this.
• Drop in the water pressure can cause back flow, especially in municipal type water systems. Using the vacuum breaker type of fitting to the hose bib end will prevent the back flow.
• Knowing where your drains and pipes are situated will help in avoiding inadvertently driving screws or nails into them. A stud sensor for detecting wirings and pipes can be used.
• Make sure the ends of connecting pipes are neatly cut. Using good quality tube cutters saw blades of reciprocal type, plastic pipe saw or hacksaw blades will help.
Copper and plastic should be cleaned thoroughly and free of burrs before you solder or use glue on them. Using pipe cleaner on the ends before applying the primer is needed for a better fix.
Selecting the Plumber
When you eye for a plumber to solve or set up your plumbing, there are certain things you should see into like the experience and the qualification he has, the quotes offered, track record, warranty and insurance, and whether the plumber or the service is readily available in case of urgent needs.
Though there are some plumbing issues that can be tackled easily on your own, not all of them can be done so. In such cases, approaching a plumbing company is the best way to solve your problem. Instead of eying for the cheapest quote, decide after looking into the requirements you have and the time frame and then choose the appropriate plumbing service for the job.
Author Box:
Kevin helps you address both your plumbing needs and issues quite easily. Whether it is detection of damages, noises or hot water heater problems, he always insists you grabbing a reliable plumber for a satisfying service.